Positioning and fixing bearing inner and outer rings

Positioning and fixing bearing inner and outer rings

Location and method of fixing the rolling bearing inner and outer rings of a lot, and there are several commonly used methods.

a) fitted with a shaft with a ring in the groove shaft, mainly for small axial force and speed is not high;

b) a shaft with a ring fastening screws, can be used to withstand large axial force at high speed, the screw should be against rotation;

c) with a round fastening nut and washers, mainly for high speed, bear large axial force situation;

d) with a conical sleeve positioning, washers and round nut for the optical axis of the bearing inner ring tapered bore.

e) use embedded within the trench hole shell fastened with an elastic ring it is mainly used for small axial force and the need to reduce the size of the apparatus when the bearing;

various types of radial f) bearing end caps fastened, for high speed, bear large axial force, thrust and radial thrust bearing;

g) is embedded with a shaft bearing outer ring with an elastic groove fastening stopper for the inconvenience when the housing is located at the shoulder;

h) with a threaded ring fastening for high speed bearings, axial force, and is not suitable for fastening the bearing cap situation.